Sub-Zero Repair in Genesee Hill
West Seattle Lead appliance: Freezer
Genesee Hill is a residential corner of West Seattle between SW Genesee Street and SW Charlestown Street, west toward 56th Avenue SW, with Ercolini Park and Genesee Hill Elementary among its streets. This page opens with the freezer, the Sub-Zero a family kitchen of this kind most often adds.
- Service valve
- Compressor
- Gauges
Pattern Ledger
Genesee Hill: how it usually goes
- Most often Coil choked with frost after a defrost part failed
-
Gives itself away by Frozen food softening over several days while the compressor keeps running and the freezer vents push little air
Price band Defrost heater, thermostat or sensor$260–$690
- Sometimes Freezer fan motor stopped or blocked
-
Gives itself away by No airflow at the vents, often once a tall bag has been pushed hard up to the back panel
Price band Evaporator or condenser fan motor$330–$690
- Rarely Freezer's own sealed system leaking or restricted
-
Gives itself away by Coil clear, fan running, condenser clean, and the freezer still sits well above zero
Price band Compressor or sealed-system repair$1,410–$3,350
Telling these three apart is what the $89 visit is for. Sub-Zero Appliance Repair Seattle · (206) 339-4211
Ice cream first, then everything else
A freezer rarely fails all at once. The ice cream turns scoopable, then soft, and a day or two later the bread and the frozen peas give in. Often there is nothing to hear or see: the compressor still hums, the display may even look normal for a while. That slow slide is the pattern that points at defrost.
On the classic built-ins the freezer carries three defrost parts that the refrigerator side does not: a heater that melts frost off the coil, a terminator that ends the heat once the coil is clear, and a heated trough that lets the water drain away. Lose any one and frost stacks up on the coil until air can no longer get through. The fan comes next on our list, then the sealed system, which is why the gauges in the frame come out last rather than first.
Checks that cost nothing
An electronic Sub-Zero freezer leaves the factory at 0°F, so look first at whether the setting has crept. Leave room between packages, because a freezer packed tight cannot move its air, and see that no door has been standing open. Sub-Zero also notes that once a zero-set freezer reads warmer than 10°F, cleaning the condenser by itself rarely brings it back; past that point it needs a diagnosis.
Getting in
These are mostly houses, some on sloping lots. When you book, say where a van can stop, whether there are steps up to the door, and which entrance is closest to the kitchen.
The details to gather
Write down the model number, the freezer reading and roughly when the softening began. Sub-Zero Appliance Repair Seattle can start sorting the likely cause on (206) 339-4211.
Customer reviews
What Seattle owners say
Built-in Sub-Zero calls in Queen Anne, Madison Park, Laurelhurst and Magnolia.
5.0/ 51,903 reviews
Frost rebuilt on the rear panel days after I scraped it off. A torn drawer seal was letting room air in and the drain was half clogged. Both dealt with in one visit. Six weeks on, none.
Nadine B.Laurelhurst
Panel-ready column, flush with the cabinetry, and I dreaded anyone pulling it out. It was the compressor relay. Back in place, and you cannot tell it moved.
Anneli P.Madison Park
Condensation beading inside the glass door had me worried about the labels. The seal had shifted and the interior fan was turning slowly, so humid air settled instead of moving. Clear through a wet month.
Soren E.Madison Park
Cabinet running warm?
Ring before the food decides for you
Give the model number and what the cabinet is doing, and the visit is booked from there. Visits 8:00 am – 8:00 pm, seven days; a person answers the phone 24/7.